Ford Tough - Home of Canadian Ford Truck Enthusiasts banner
1 - 7 of 7 Posts

· Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I am trying to find headers for my truck.
It's an 80 F-150 2wd with a 302 that someone swapped from a Capri.
Would headers for a truck that came from the factory with a 302 work?
Or do I need a different set? If so, where could I get them?

Any help is appreciated
 

· Registered
Joined
·
506 Posts
The intakes and cams are different, other than that there 100% identical motor depending on years as some are a roller motor(85-93) and some are flat tappet motors(pre 85). All 302 headers will fit the engine but not neccessarily the vehicle.
 

· Registered
Joined
·
16 Posts
I just installed a set of Flow tech headers on my 95 F-150.went pretty smooth.I only went headers because the dealership manifold on the right side was way more than a set of headers.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top